Passive Door Lock Not Working

The other door lock buttons the remotes and the lock switch in the console all worked fine.

Passive door lock not working.

They work fine on the passenger side however on the driver front and rear door they do not work. The doors will not unlock if they do not sense the programmed matched fob. Why don t you try disabling passive entry via the uconnect settings lock unlock the car via the fob and then re enable it in uconnect and try again. You must remove the door pad to access this.

To disable the unlocking feature with the vehicle off press and hold the lock and unlock buttons on the key fob for three seconds. One is the battery powered section that operates the remote door lock unlock. It will operate with a dead battery. The turn signals will flash four times to indicate that passive unlocking is now disabled.

I went into a store left the car running and when i came back out the doors were unlocked. It may return to normal. There are multiple short range antennas in your gc including one around the perimeter of the spare tire well for tailgate operation. The dealer replaced the outer door lock handle had to have it painted before installation.

Eventually it stopped working altogether. With passive unlocking disabled the doors will remain locked when pressing the button on the door handle. The second is a rfid like toll roads use and operates the passive entry and push to start. I ve checked the settings multiple times and even turned off and on the passive door lock feature and it is on but it is not working whenever i leave my vehicle running the doors stay open any thoughts or.

Through some investigation i have found that there is a second antenna system inside the rear passenger door. Got the service keyless system message then the next day all passive entry options were not working. The exterior passive lock unlock buttons on the doorhandles of my yukon do not work.