Pella Sliding Door Lock Not Working

This will loosen the tension on the deadbolt allowing it to retract and the door to open.

Pella sliding door lock not working.

Make sure the door slides easily and latches. This sliding glass door lock was not working. The door might be difficult to latch and release if the strikes are misaligned. Flip the lock lever on the side of the door down so that it extends the door latch out of the door.

Pry off the plastic covers loosen the screws and slide the strikes up or down a few millimeters. Open and close the door a few times to check for proper operation. Donations appreciated click in upper right corner info circle. If the lock does not align with the strike go to step e then return to step b.

To unjam the deadbolt remove the latch side rail installation screws. Once the mechanism has been released adjust stiff pella sliding door locks by loosening the screws holding the latching strikes on the inside of the door frame. If there are any problems with the door travel recheck and adjust for plumb and square. Each case of stuck door can have its own challenges and solutions due to the variety of factors that can contribute to this type of situation and because of the many different door designs door hardware and door functions.

It did not latch shut. What can i do if my deadbolt is stuck or not working. Open the pella sliding door enough so that you have room to stand and work between the door edge and the door. 2 test the operation of the sliding door a.

Discover pella s energy efficient replacement windows and doors. The storm door deadbolt and latch side rail are likely misaligned which can prevent the deadbolt from retracting.